3DXTech HIPS Standard
1.75 mm
1000 g
1.04 g/cm³
400 m
230–245 °C
90–110 °C
0.98
Drying: 60-65 °C for 2-4 h
Material properties · 38 fields
Inherited from HIPS.
Printing requirements
230-245 °C
90-110°C
Off
Off
Warm (35-55°C) · enclosure needed
High
HEPA + Carbon Filtration, Exhaust Outdoors
Removes both ultrafine particles and many VOCs. Best all-around filtration. Removes particles and VOCs from the indoor environment entirely.
0.98
Recommended (Brim, Glue (adhesion), Magigoo, ABS/ASA Slurry, Tape)
Recommended
Not needed
60-65 °C for 2-4 h
Printing characteristics
Goodⓘ
Moderate
0.4-0.7 %
Moderateⓘ
Easy
Goodⓘ
Goodⓘ
Lowⓘ
Lowⓘ
Moderateⓘ
120 mm/s
Low
Strong
High
Material properties
1.04 g/cm³
Low · 30 MPa
Medium · 1.90 GPa
Medium · 10.0 kJ/m²
Rigid · 30% elong.
Medium · 85 °C HDT
100 °C
Low · 0.05% in 24h
Low · 40 MPa
Medium · 1.90 GPa
Poor
Poor
Series created Jun 26, 2026 · Last updated Jun 26, 2026
Specialties
Dissolvable SupportA water-soluble or limonene-soluble filament used exclusively as support material that can be washedPVA is the most common water-soluble example.
Easy PrintFormulated to reduce warping and curling. Prints on unenclosed printers without lifting off the bed. Often PLA-based with additives that lower internal stresses. Great for large flat parts.
SandableEasily sanded, filed, or carved without gumming up sandpaper.
LightweightVery light, often foaming or low-density. Floats in water. Often used for RC planes, drones, and buoyant objects
Tough / Impact ResistantEngineered to resist breaking, cracking, or shattering under impact. Unlike standard PLA, which snaps, this flexes slightly before breaking. Ideal for parts that get dropped, bumped, or stressed.
Low OdorEngineered to reduce harmful emissions and smells during printing. Safer for home or office use without industrial ventilation. Most common in ABS and ASA alternatives.