Updated Jul 7, 2026Added Jul 7, 2026
3DXTech PA (Nylon) FIBREX™ Nylon PA6+GF30
Filaments in this series (5)
Printable on practically any 3D printer with a heated bed
Ideal for structural engineering-grade applications
Exceptionally stiff and strong, without being brittle
Excellent chemical resistance makes it suitable for automotive and industrial applications
Resists fuels, lubricants, heat, and mechanical loading
High thermal properties keep it strong up to 170C in use, depending on printing and mechanical loads applied
Glass fiber reinforcement improves dimensional stability, reduces shrinkage, lift, and warp
1.75 mm
750 g
1.35 g/cm³
231 m
260–280 °C
60–75 °C
0.4 mm+
1
Hardened required
Drying: 90 °C for 4 h
Specialties
Glass FiberContains chopped glass fibers in a base polymer. Increases toughness, impact resistance, and heat deflection. Available in multiple colors (unlike carbon fiber). Highly abrasive.
Tough / Impact ResistantEngineered to resist breaking, cracking, or shattering under impact. Unlike standard PLA, which snaps, this flexes slightly before breaking. Ideal for parts that get dropped, bumped, or stressed.
Wear ResistantResists surface wear from friction and sliding. Good for gears, bushings, conveyor parts, or any component that rubs against other surfaces.
High StrengthResists bending or pulling apart under heavy load. Very stiff.
Chemical ResistantResists damage from oils, fuels, acids, industrial chemicals or solvents. For laboratory equipment, fuel system components, or chemical storage.
Heat ResistantWithstands elevated temperatures (hot car, warm electronics) without deforming. Printable on standard printers. HDT ~80-120°C.
Low Friction Naturally slippery surface. Low coefficient of friction. For bearings and sliding parts.