Updated Jul 7, 2026Added Jul 7, 2026
3DXTech PA (Nylon) WearX PA6
Filaments in this series (1)
WearX PA6 offers a harder surface, improved dimensional stability, and a matte surface appearance. This material was inspired by the need for an enhanced material specifically formulated to resist sliding and rotational wear.
1.75 mm
500 g
1.18 g/cm³
176 m
260–275 °C
80–95 °C
0.2 mm+
1
Drying: 90 °C for 6 h
Specialties
MatteFlat, non-reflective surface that hides layer lines. Surface feels slightly rough or chalky.
Tough / Impact ResistantEngineered to resist breaking, cracking, or shattering under impact. Unlike standard PLA, which snaps, this flexes slightly before breaking. Ideal for parts that get dropped, bumped, or stressed.
Wear ResistantResists surface wear from friction and sliding. Good for gears, bushings, conveyor parts, or any component that rubs against other surfaces.
High StrengthResists bending or pulling apart under heavy load. Very stiff.
Chemical ResistantResists damage from oils, fuels, acids, industrial chemicals or solvents. For laboratory equipment, fuel system components, or chemical storage.
Heat ResistantWithstands elevated temperatures (hot car, warm electronics) without deforming. Printable on standard printers. HDT ~80-120°C.
Low Friction Naturally slippery surface. Low coefficient of friction. For bearings and sliding parts.