Added Jun 4, 2026
Bambu Lab PA (Nylon) PA6-CF
Filaments in this series (1)
1.75 mm
1000 g
1.09 g/cm³
381 m
260–290 °C
80–100 °C
1
Drying: 70-90 °C for 8-24 h
Specialties
Tough / Impact ResistantEngineered to resist breaking, cracking, or shattering under impact. Unlike standard PLA, which snaps, this flexes slightly before breaking. Ideal for parts that get dropped, bumped, or stressed.
Wear ResistantResists surface wear from friction and sliding. Good for gears, bushings, conveyor parts, or any component that rubs against other surfaces.
High StrengthResists bending or pulling apart under heavy load. Very stiff.
Chemical ResistantResists damage from oils, fuels, acids, industrial chemicals or solvents. For laboratory equipment, fuel system components, or chemical storage.
Heat ResistantWithstands elevated temperatures (hot car, warm electronics) without deforming. Printable on standard printers. HDT ~80-120°C.
Low Friction Naturally slippery surface. Low coefficient of friction. For bearings and sliding parts.