Added Jun 6, 2026
Your spools
Sign in to see your spools of this filament here, how much is left, and where each one lives.
Photos
No community photos of AMOLEN PLA Basic High Speed Ocean Blue yet.
Upload your swatch, spool or print with this filament.
Join to add a photo
or sign inAMOLEN PLA Basic High Speed Ocean Blue Summary
This filament is beginner-friendly to print. Worth watching: it can be low on heat resistance.
Beginner
Beginner-friendly. Prints reliably at default settings on almost any printer.
Print characteristics
Layer adhesion GoodBed adhesion EasyBridging & overhang ExcellentSpeed sensitivity LowWarping NoneShrinkage 0.2-0.6 %Stringing MinimalOozing MinimalOdor Mild
Strengths
- Solid strength for everyday parts
- Stiff and rigid, resists flexing
- Stays flat, very little warping
- Prints clean with minimal stringing
- Food-safe potential with the right setup
Things to watch
- Softens in heat, not for hot cars or near heat sources
- Degrades in sunlight, not ideal for long-term outdoor use
- Can be brittle, may crack under sharp impact
- Wears down under friction, not for high-wear parts
Color & finish
A solid Ocean Blue filament. It reads as a blue, close to steel blue.
Finishing
SandablePaintableVapor-smoothableMachinableGlue-friendly
Common uses
Decor & Cosplay
Display modelsFigurines & statues
Home & Lifestyle
Drawer organizersPlanters
Tabletop & Gaming
Board game insertsMiniatures
Specialties
BasicDefault finish with no special surface treatment; slight natural sheen. Prints with a slightly glossy surface and visible layer lines, and is the baseline against which all other finishes are compared.
High SpeedFlows like water, cools instantly. Prints fast (200mm/s+) without clogging. Usually matte finish.
Spool Specs
1.25 g/cm³
±0.02 mm
1.75 mm
1000 g
333 m
Filament Print & Drying settings
| Nozzle temp | 190–230 °C |
|---|---|
| Bed temp | 30–65 °C |
| Print speed | < 600 mm/s |
| Flow ratio | 1 |
| Drying | 50 °C for 8 h |
| Moisture sensitivity | Low |
| Enclosure | Not Required |
| Part cooling | Max |
More in the Basic High Speed series
View all 16 colors
Apple Red
Carrot Orange
Charcoal Black
Chestnut Brown
Eggplant Purple
Forest Green
Ice Blue
Koala Gray
Lavender Purple
Lime Green
Paper White
Peach Fuzz
Real Gold
Sakura Pink
Sand BeigeReviews for AMOLEN PLA Basic High Speed Ocean Blue filament
Be the first to review. Join for free or sign in to share your experience and prints with this filament.