Tigerwood· AMOLEN PLA Wood
Updated Jun 27, 2026
GradientWood
Very easy
Beginner-friendly. Prints reliably at default settings on almost any printer.
Sign up to follow this filament
Your spools, shelves, and drying logs, all in one visual studio.
$29.99/kg
Buy links may earn VisualSpool a small commission, at no extra cost to you.
Details.
Your spools
Sign in to see your spools of this filament here, how much is left, and where each one lives.
AMOLEN PLA Wood Tigerwood Summary
This filament is beginner-friendly to print. Worth watching: it can be low on heat resistance.
Print characteristics
Layer adhesion GoodBed adhesion ModerateBridging & overhang ExcellentSpeed sensitivity ModerateWarping LowShrinkage 0.2-0.6 %Stringing LowOozing LowOdor Mild
Strengths
- Solid strength for everyday parts
- Stiff and rigid, resists flexing
- Stays flat, very little warping
- Prints clean with minimal stringing
- Food-safe potential with the right setup
Things to watch
- Softens in heat, not for hot cars or near heat sources
- Degrades in sunlight, not ideal for long-term outdoor use
- Can be brittle, may crack under sharp impact
- Wears down under friction, not for high-wear parts
Drying
This material is fairly forgiving about moisture. When it needs drying, run it at 40-50 °C for 4-6 h.
Compatibility
Not Required
Max
180–210 °C
30–65 °C
Color
This is a multi-color filament in Rosewood, Ebony, Burgundy, and Walnut.
Finish
This filament has a wood-like texture and finish and a color-shifting gradient as it prints.
Finishing
SandablePaintableVapor-smoothableMachinableGlue-friendly
Common uses
🎨 Art & Cosplay
Display modelsFigurines & statues
🏡 Home
Drawer organizersPlanters
🎲 Gaming
Board game insertsMiniatures
Specialties
GradientThe color transitions as the print progresses. One spool can start blue and end pink, or cycle through a full rainbow.
WoodContains ground wood fibers or cork. Creates wood-like texture, color, and smell. Can be sanded and stained like real wood. Lighter than standard PLA.
Spool Specs
1.23 g/cm³
±0.02 mm
1.75 mm
1000 g
338 m
Filament Print & Drying settings
| Nozzle temp | 180–210 °C |
|---|---|
| Bed temp | 30–65 °C |
| Print speed | < 250 mm/s |
| Flow ratio | 1 |
| Drying | 55 ± 5 °C for 6–8 hours |
| Moisture sensitivity | Low |
| Enclosure | Not Required |
More in the Wood series
View all 11 colors
Photos
No community photos of AMOLEN PLA Wood Tigerwood yet.
Upload your swatch, spool or print with this filament.
Join to add a photo
or sign inReviews for AMOLEN PLA Wood Tigerwood filament
Be the first to review. Join for free or sign in to share your experience and prints with this filament.