Caramel· Anycubic PLA Matte

Anycubic

Filament Color

Caramel#C4A981

Buy

Anycubic Store Buy on Amazon

Buy links may earn VisualSpool a small commission, at no extra cost to you. Details.

Your spools

Create your studio Sign in

Photos

No community photos of Anycubic PLA Matte Caramel yet.

Upload your swatch, spool or print with this filament.

Join to add a photo or sign in

Anycubic PLA Matte Caramel Summary

This filament is beginner-friendly to print. Worth watching: it can be low on heat resistance.

Skill level Beginner

Beginner-friendly. Prints reliably at default settings on almost any printer.

Print characteristics

Layer adhesion GoodBed adhesion EasyBridging & overhang ExcellentSpeed sensitivity LowWarping NoneShrinkage 0.2-0.6 %Stringing MinimalOozing MinimalOdor Mild

Strengths

Solid strength for everyday parts
Stiff and rigid, resists flexing
Stays flat, very little warping
Prints clean with minimal stringing
Food-safe potential with the right setup

Things to watch

Softens in heat, not for hot cars or near heat sources
Degrades in sunlight, not ideal for long-term outdoor use
Can be brittle, may crack under sharp impact
Wears down under friction, not for high-wear parts

Color & finish

A solid Caramel filament. It reads as a light orange, close to tan. This filament has a flat, matte finish that hides layer lines.

Finishing

SandablePaintableVapor-smoothableMachinableGlue-friendly

Common uses

Decor & Cosplay Display modelsFigurines & statues

Home & Lifestyle Drawer organizersPlanters

Tabletop & Gaming Board game insertsMiniatures

Specialties

MatteFlat, non-reflective surface that hides layer lines. Surface feels slightly rough or chalky.

Spool Specs

DENSITY

1.25 g/cm³

TOLERANCE

±0.03 mm

DIAMETER

1.75 mm

SPOOL SIZE

1000 g

LENGTH

333 m

Filament Print & Drying settings

Nozzle temp	190–230 °C
Bed temp	60–65 °C
Print speed	50–250 mm/s
Flow ratio	1
Max volumetric flow	12 mm³/s
Drying	60 °C for 8 h
Moisture sensitivity	Low
Enclosure	Not Required
Part cooling	Max