Updated Jul 26, 2026Added Jul 26, 2026
Misty Blue· Bambu Lab PETG Basic
AMS compatible
Buy links may earn VisualSpool a small commission, at no extra cost to you.
Details.
Your spools
Sign in to see your spools of this filament here, how much is left, and where each one lives.
Photos
No community photos of Bambu Lab PETG Basic Misty Blue yet.
Upload your swatch, spool or print with this filament.
Join to add a photo
or sign inBambu Lab PETG Basic Misty Blue Summary
This filament is easy to print, weatherproof. Worth watching: it can be a little moisture-sensitive.
Easy
Easygoing. Consistent results with very little tuning.
Print characteristics
Layer adhesion ExcellentBed adhesion EasyBridging & overhang GoodSpeed sensitivity HighWarping LowShrinkage 0.2-0.8 %Stringing HighOozing HighOdor None
Strengths
- Solid strength for everyday parts
- Weather-resistant for long-term outdoor use
- Layers bond strongly for clean, watertight prints
- Stays flat, very little warping
- Good electrical insulator
- Food-safe potential with the right setup
Things to watch
- Picks up moisture over time, store it with desiccant
- Prone to stringing, tune retraction and keep the filament dry
- Oozes from the nozzle, expect some cleanup on multi-part prints
Color & finish
A solid Misty Blue filament. It reads as a muted blue, close to slate gray.
Finishing
Glue-friendly
Common uses
Mechanical & Structural
Brackets
Home & Lifestyle
Cable managementHooks & hangersKitchen accessories
Outdoor & Auto
Garden & outdoor fixtures
Electronics & RC
Electronics enclosures
Specialties
BasicDefault finish with no special surface treatment; slight natural sheen. Prints with a slightly glossy surface and visible layer lines, and is the baseline against which all other finishes are compared.
Chemical ResistantResists damage from oils, fuels, acids, industrial chemicals or solvents. For laboratory equipment, fuel system components, or chemical storage.
Tough / Impact ResistantEngineered to resist breaking, cracking, or shattering under impact. Unlike standard PLA, which snaps, this flexes slightly before breaking. Ideal for parts that get dropped, bumped, or stressed.
Heat ResistantWithstands elevated temperatures (hot car, warm electronics) without deforming. Printable on standard printers. HDT ~80-120°C.
UV ResistantResists degradation from sunlight exposure (UV radiation) and outdoor weather conditions. For outdoor signage, garden equipment, automotive exterior parts, or marine components.
Low OdorEngineered to reduce harmful emissions and smells during printing. Safer for home or office use without industrial ventilation. Most common in ABS and ASA alternatives.
Water Resistant / HydrophobicResists absorbing water or moisture from the air. Maintains mechanical properties in humid or wet environments. For marine parts, outdoor components, or wet environment applications.
Spool Specs
1.27 g/cm³
±0.03 mm
1.75 mm
1000 g
327 m
Filament Print & Drying settings
| Nozzle temp | 230–260 °C |
|---|---|
| Bed temp | 65–75 °C |
| Print speed | < 200 mm/s |
| Flow ratio | 0.98 |
| Drying | 60-65 °C for 4-6 h |
| Moisture sensitivity | Medium |
| Enclosure | Optional |
| Part cooling | Medium |
| Dry box while printing | Keep the spool in a dry box while printing |
More in the Basic series
View all 12 colors
Reviews for Bambu Lab PETG Basic Misty Blue filament
Be the first to review. Join for free or sign in to share your experience and prints with this filament.