Added Jun 6, 2026
Pink· Bambu Lab PLA Glow
AMS compatible
Buy links may earn VisualSpool a small commission, at no extra cost to you.
Details.
Your spools
Sign in to see your spools of this filament here, how much is left, and where each one lives.
Photos
No community photos of Bambu Lab PLA Glow Pink yet.
Upload your swatch, spool or print with this filament.
Join to add a photo
or sign inBambu Lab PLA Glow Pink Summary
This filament is beginner-friendly to print. Worth watching: it can be low on heat resistance.
Beginner
Beginner-friendly. Prints reliably at default settings on almost any printer.
Print characteristics
Layer adhesion GoodBed adhesion EasyBridging & overhang ExcellentSpeed sensitivity LowWarping NoneShrinkage 0.2-0.6 %Stringing MinimalOozing MinimalOdor Mild
Strengths
- Solid strength for everyday parts
- Stiff and rigid, resists flexing
- Stays flat, very little warping
- Prints clean with minimal stringing
- Food-safe potential with the right setup
Things to watch
- Softens in heat, not for hot cars or near heat sources
- Degrades in sunlight, not ideal for long-term outdoor use
- Can be brittle, may crack under sharp impact
- Wears down under friction, not for high-wear parts
Color & finish
A solid Pink filament. It reads as a light, vivid pink, close to light coral. This filament has a glow-in-the-dark effect after a charge of light.
Finishing
SandablePaintableVapor-smoothableMachinableGlue-friendly
Common uses
Decor & Cosplay
Display modelsFigurines & statues
Home & Lifestyle
Drawer organizersPlanters
Tabletop & Gaming
Board game insertsMiniatures
Specialties
Glow in the DarkAbsorbs light from the sun or room lighting, then slowly releases it as a glow in the dark. Lasts for minutes to hours. Green is most common. Highly abrasive—use a hardened nozzle.
Spool Specs
1.24 g/cm³
±0.03 mm
1.75 mm
1000 g
335 m
Filament Print & Drying settings
| Nozzle temp | 190–230 °C |
|---|---|
| Bed temp | 35–45 °C |
| Print speed | < 250 mm/s |
| Flow ratio | 1 |
| Drying | 40-50 °C for 4-6 h |
| Moisture sensitivity | Low |
| Enclosure | Not Required |
| Part cooling | Max |
More in the Glow series
View all 5 colors
Reviews for Bambu Lab PLA Glow Pink filament
Be the first to review. Join for free or sign in to share your experience and prints with this filament.