Silver· Bambu Lab PLA Tough+
Tough / Impact Resistant
AMS compatible
Very easy
Beginner-friendly. Prints reliably at default settings on almost any printer.
Sign up to follow this filament
Your spools, shelves, and drying logs, all in one visual studio.
Buy links may earn VisualSpool a small commission, at no extra cost to you.
Details.
Your spools
Sign in to see your spools of this filament here, how much is left, and where each one lives.
Bambu Lab PLA Tough+ Silver Summary
This filament is beginner-friendly to print. Worth watching: it can be low on heat resistance.
Print characteristics
Layer adhesion GoodBed adhesion ModerateBridging & overhang ExcellentSpeed sensitivity ModerateWarping LowShrinkage 0.2-0.6 %Stringing LowOozing LowOdor Mild
Strengths
- Solid strength for everyday parts
- Stiff and rigid, resists flexing
- Stays flat, very little warping
- Prints clean with minimal stringing
- Food-safe potential with the right setup
Things to watch
- Softens in heat, not for hot cars or near heat sources
- Degrades in sunlight, not ideal for long-term outdoor use
- Can be brittle, may crack under sharp impact
- Wears down under friction, not for high-wear parts
Drying
This material is fairly forgiving about moisture. When it needs drying, run it at 40-50 °C for 4-6 h.
Compatibility
Compatible
Not Required
Max
220–250 °C
35–65 °C
Color
A solid Silver filament. It reads as a soft light grey, close to rosy brown.
Finishing
SandablePaintableVapor-smoothableMachinableGlue-friendly
Common uses
🎨 Art & Cosplay
Display modelsFigurines & statues
🏡 Home
Drawer organizersPlanters
🎲 Gaming
Board game insertsMiniatures
Specialties
Tough / Impact ResistantEngineered to resist breaking, cracking, or shattering under impact. Unlike standard PLA, which snaps, this flexes slightly before breaking. Ideal for parts that get dropped, bumped, or stressed.
Spool Specs
1.24 g/cm³
±0.03 mm
1.75 mm
1000 g
335 m
Filament Print & Drying settings
| Nozzle temp | 220–250 °C |
|---|---|
| Bed temp | 35–65 °C |
| Print speed | < 300 mm/s |
| Flow ratio | 1 |
| Drying | 40-50 °C for 4-6 h |
| Moisture sensitivity | Low |
| Enclosure | Not Required |
More in the Tough+ series
View all 7 colors
Photos
No community photos of Bambu Lab PLA Tough+ Silver yet.
Upload your swatch, spool or print with this filament.
Join to add a photo
or sign inReviews for Bambu Lab PLA Tough+ Silver filament
Be the first to review. Join for free or sign in to share your experience and prints with this filament.