Green· JAYO PLA Standard
Updated Jul 7, 2026
Basic
Beginner
Beginner-friendly. Prints reliably at default settings on almost any printer.
Sign up to follow this filament
Your spools, shelves, and drying logs, all in one visual studio.
$14.54/kg
Buy links may earn VisualSpool a small commission, at no extra cost to you.
Details.
Photos
No community photos of JAYO PLA Standard Green yet.
Upload your swatch, spool or print with this filament.
Join to add a photo
or sign inYour spools
Sign in to see your spools of this filament here, how much is left, and where each one lives.
JAYO PLA Standard Green Summary
This filament is beginner-friendly to print. Worth watching: it can be low on heat resistance.
Print characteristics
Layer adhesion GoodBed adhesion EasyBridging & overhang ExcellentSpeed sensitivity LowWarping NoneShrinkage 0.2-0.6 %Stringing MinimalOozing MinimalOdor Mild
Strengths
- Solid strength for everyday parts
- Stiff and rigid, resists flexing
- Stays flat, very little warping
- Prints clean with minimal stringing
- Food-safe potential with the right setup
Things to watch
- Softens in heat, not for hot cars or near heat sources
- Degrades in sunlight, not ideal for long-term outdoor use
- Can be brittle, may crack under sharp impact
- Wears down under friction, not for high-wear parts
Color & finish
A solid Green filament. It reads as a vivid green, close to lime green.
Finishing
SandablePaintableVapor-smoothableMachinableGlue-friendly
Common uses
Decor & Cosplay
Display modelsFigurines & statues
Home & Lifestyle
Drawer organizersPlanters
Tabletop & Gaming
Board game insertsMiniatures
Specialties
BasicDefault finish with no special surface treatment; slight natural sheen. Prints with a slightly glossy surface and visible layer lines, and is the baseline against which all other finishes are compared.
Spool Specs
1.24 g/cm³
±0.02 mm
1.75 mm
1100 g
369 m
Filament Print & Drying settings
| Nozzle temp | 200–240 °C |
|---|---|
| Bed temp | 50–60 °C |
| Print speed | 50–300 mm/s |
| Flow ratio | 1 |
| Drying | 40-50 °C for 4-6 h |
| Moisture sensitivity | Low |
| Enclosure | Not Required |
| Part cooling | Max |
More in the Standard series
View all 14 colors
Black
Blue
Cherry Pink
Chocolate
Clear
Gray
Magenta
Olive Green
Red
Sky Blue
Sunshine Orange
White
YellowReviews for JAYO PLA Standard Green filament
Be the first to review. Join for free or sign in to share your experience and prints with this filament.