Rainbow 02· JAYO PLA Silk
Updated Jul 7, 2026
GradientSilk
Beginner
Beginner-friendly. Prints reliably at default settings on almost any printer.
Sign up to follow this filament
Your spools, shelves, and drying logs, all in one visual studio.
$18.17/kg
Buy links may earn VisualSpool a small commission, at no extra cost to you.
Details.
Photos
No community photos of JAYO PLA Silk Rainbow 02 yet.
Upload your swatch, spool or print with this filament.
Join to add a photo
or sign inYour spools
Sign in to see your spools of this filament here, how much is left, and where each one lives.
JAYO PLA Silk Rainbow 02 Summary
This filament is beginner-friendly to print. Worth watching: it can be low on heat resistance.
Print characteristics
Layer adhesion GoodBed adhesion EasyBridging & overhang ExcellentSpeed sensitivity LowWarping NoneShrinkage 0.2-0.6 %Stringing MinimalOozing MinimalOdor Mild
Strengths
- Solid strength for everyday parts
- Stiff and rigid, resists flexing
- Stays flat, very little warping
- Prints clean with minimal stringing
- Food-safe potential with the right setup
Things to watch
- Softens in heat, not for hot cars or near heat sources
- Degrades in sunlight, not ideal for long-term outdoor use
- Can be brittle, may crack under sharp impact
- Wears down under friction, not for high-wear parts
Color & finish
A solid Rainbow 02 filament. It reads as a vivid blue, close to steel blue. This filament has a silky, high-gloss sheen and a color-shifting gradient as it prints.
Finishing
SandablePaintableVapor-smoothableMachinableGlue-friendly
Common uses
Decor & Cosplay
Display modelsFigurines & statues
Home & Lifestyle
Drawer organizersPlanters
Tabletop & Gaming
Board game insertsMiniatures
Specialties
GradientThe color transitions as the print progresses. One spool can start blue and end pink, or cycle through a full rainbow.
SilkExtremely smooth and glossy with a satin-like sheen. Color is static and highly reflective.
Spool Specs
1.24 g/cm³
±0.02 mm
1.75 mm
1100 g
369 m
Filament Print & Drying settings
| Nozzle temp | 200–230 °C |
|---|---|
| Bed temp | 60–80 °C |
| Print speed | 50–200 mm/s |
| Flow ratio | 1 |
| Drying | 40-50 °C for 4-6 h |
| Moisture sensitivity | Low |
| Enclosure | Not Required |
| Part cooling | Max |
More in the Silk series
View all 22 colors
Black
Blue
Dual Black Gold
Dual Black Green
Dual Black Purple
Dual Blue Green
Dual Red Blue
Dual Red Gold
Gold
Green
Orange
Pink
Quad Black Red Yellow Gray
Quad Gold Purple Red Blue
Quad Red Yellow Green Black
Rainbow 03
Rainbow 04
Red
Red Copper
Silver
WhiteReviews for JAYO PLA Silk Rainbow 02 filament
Be the first to review. Join for free or sign in to share your experience and prints with this filament.