Glow Red· Overture PLA Easy
Glow in the Dark
Very easy
Beginner-friendly. Prints reliably at default settings on almost any printer.
Sign up to follow this filament
Your spools, shelves, and drying logs, all in one visual studio.
Buy links may earn VisualSpool a small commission, at no extra cost to you.
Details.
Your spools
Sign in to see your spools of this filament here, how much is left, and where each one lives.
Overture PLA Easy Glow Red Summary
This filament is beginner-friendly to print. Worth watching: it can be low on heat resistance.
Print characteristics
Layer adhesion GoodBed adhesion ModerateBridging & overhang ExcellentSpeed sensitivity ModerateWarping LowShrinkage 0.2-0.6 %Stringing LowOozing LowOdor Mild
Strengths
- Solid strength for everyday parts
- Stiff and rigid, resists flexing
- Stays flat, very little warping
- Prints clean with minimal stringing
- Food-safe potential with the right setup
Things to watch
- Softens in heat, not for hot cars or near heat sources
- Degrades in sunlight, not ideal for long-term outdoor use
- Can be brittle, may crack under sharp impact
- Wears down under friction, not for high-wear parts
Drying
This material is fairly forgiving about moisture. When it needs drying, run it at 40-50 °C for 4-6 h.
Compatibility
Not Required
Max
190–220 °C
25–60 °C
Color
A solid Glow Red filament. It reads as a light, vivid red, close to salmon.
Finish
This filament has a glow-in-the-dark effect after a charge of light.
Finishing
SandablePaintableVapor-smoothableMachinableGlue-friendly
Common uses
🎨 Art & Cosplay
Display modelsFigurines & statues
🏡 Home
Drawer organizersPlanters
🎲 Gaming
Board game insertsMiniatures
Specialties
Glow in the DarkAbsorbs light from the sun or room lighting, then slowly releases it as a glow in the dark. Lasts for minutes to hours. Green is most common. Highly abrasive—use a hardened nozzle.
Spool Specs
1.24 g/cm³
±0.03 mm
1.75 mm
1000 g
335 m
Filament Print & Drying settings
| Nozzle temp | 190–220 °C |
|---|---|
| Bed temp | 25–60 °C |
| Print speed | 40–60 mm/s |
| Flow ratio | 1 |
| Drying | 40-50 °C for 4-6 h |
| Moisture sensitivity | Low |
| Enclosure | Not Required |
More in the Easy series
View all 26 colors
Beige
Black
Caramel
Cobalt Blue
Digital Blue
Glow Blue
Glow Orange
Glow Yellow
Green
Magenta
Natural
Orange
Pink
Pumpkin Orange
Purple
Red
Rock White
Shimmer Bronze
Shimmer Dark Green
Shimmer Purple
Shimmer Silver Green
Space Gray
White
Yellow+1
morePhotos
No community photos of Overture PLA Easy Glow Red yet.
Upload your swatch, spool or print with this filament.
Join to add a photo
or sign inReviews for Overture PLA Easy Glow Red filament
Be the first to review. Join for free or sign in to share your experience and prints with this filament.