Updated Jul 8, 2026Added Jun 6, 2026
Orange· Overture PLA Standard
Buy links may earn VisualSpool a small commission, at no extra cost to you.
Details.
Your spools
Sign in to see your spools of this filament here, how much is left, and where each one lives.
Photos of Orange · Overture PLA Standard
Refill
Photos
No community photos of Overture PLA Standard Orange yet.
Upload your swatch, spool or print with this filament.
Join to add a photo
or sign inOverture PLA Standard Orange Summary
This filament is beginner-friendly to print. Worth watching: it can be low on heat resistance.
Beginner
Beginner-friendly. Prints reliably at default settings on almost any printer.
Print characteristics
Layer adhesion GoodBed adhesion EasyBridging & overhang ExcellentSpeed sensitivity LowWarping NoneShrinkage 0.2-0.6 %Stringing MinimalOozing MinimalOdor Mild
Strengths
- Solid strength for everyday parts
- Stiff and rigid, resists flexing
- Stays flat, very little warping
- Prints clean with minimal stringing
- Food-safe potential with the right setup
Things to watch
- Softens in heat, not for hot cars or near heat sources
- Degrades in sunlight, not ideal for long-term outdoor use
- Can be brittle, may crack under sharp impact
- Wears down under friction, not for high-wear parts
Color & finish
A solid Orange filament. It reads as a light, vivid orange, close to dark orange.
Finishing
SandablePaintableVapor-smoothableMachinableGlue-friendly
Common uses
Decor & Cosplay
Display modelsFigurines & statues
Home & Lifestyle
Drawer organizersPlanters
Tabletop & Gaming
Board game insertsMiniatures
Specialties
BasicDefault finish with no special surface treatment; slight natural sheen. Prints with a slightly glossy surface and visible layer lines, and is the baseline against which all other finishes are compared.
High SpeedFlows like water, cools instantly. Prints fast (200mm/s+) without clogging. Usually matte finish.
Spool Specs
1.24 g/cm³
±0.02 mm
1.75 mm
1000 g
335 m
Filament Print & Drying settings
| Nozzle temp | 190–230 °C |
|---|---|
| Bed temp | 25–60 °C |
| Print speed | 40–300 mm/s |
| Flow ratio | 1 |
| Drying | 55 °C for 6 h |
| Moisture sensitivity | Low |
| Enclosure | Not Required |
| Part cooling | Max |
More in the Standard series
View all 33 colors
Aurora Berry
Avocado
Black
Blue
Brown
Cement Gray
Champagne Frost
Chocolate
Christmas Prism
Cold White
Fresh Red
Gray Blue
Green
Highlight Yellow
Lemon Yellow
Light Blue
Light Gray
Metallic Gray
Northern Lights
Olive Green
Pink
Purple
Rainbow
Red+8
moreReviews for Overture PLA Standard Orange filament
Be the first to review. Join for free or sign in to share your experience and prints with this filament.