3DXTech PC CarbonX ezPC+CF
Filaments in this series
High thermal properties, especially when reinforced with carbon fiber
Amorphous structure gives it low, near isotropic shrinkage (very low CTE)
Further improved stiffness and dimensional stability with the addition of carbon fiber reinforcement
Very low odor emitted while printing
Wide processing range of 260-280°C (suitable for most desktop printers)
1.75 mm
500 g
1.36 g/cm³
153 m
260–280 °C
80–100 °C
0.4 mm+
0.95
Hardened required
$140.00
Drying: 80 °C for 4 h
Material properties · 40 fields
Inherited from PC.
Printing requirements
260-300 °C
110°C+
Off, Low 25%
Off
Heated (55-75°C) · enclosure needed
High
Open Window / Room Ventilation, HEPA + Carbon Filtration
Dilutes airborne contaminants but doesn't filter them. Removes both ultrafine particles and many VOCs. Best all-around filtration.
0.95
Required (Brim, Glue (adhesion), Magigoo, ABS/ASA Slurry)
Required
Required
80-100 °C for 4-24 h
Printing characteristics
Process-Dependentⓘ
High
0.5-0.8 %
Requires Special Prepⓘ
Challenging
Excellentⓘ
Fairⓘ
Moderateⓘ
Moderateⓘ
Highⓘ
60 mm/s
High
Moderate
High
Material properties
1.20 g/cm³
High · 60 MPa
Medium · 2.20 GPa
High · 15.0 kJ/m²
Rigid · 8% elong.
High · 115 °C HDT
145 °C
Low · 0.30% in 24h
High · 90 MPa
Medium · 2.30 GPa
Good
Fair
Good
Good
Series created Jul 7, 2026 · Last updated Jul 7, 2026
Specialties
Carbon FiberContains chopped carbon fibers in a base polymer (PLA, ABS, Nylon, PETG, ASA). Creates extremely stiff, lightweight, dimensionally stable parts. Matte black finish only. Highly abrasive.
High StrengthResists bending or pulling apart under heavy load. Very stiff.
Heat ResistantWithstands elevated temperatures (hot car, warm electronics) without deforming. Printable on standard printers. HDT ~80-120°C.
Tough / Impact ResistantEngineered to resist breaking, cracking, or shattering under impact. Unlike standard PLA, which snaps, this flexes slightly before breaking. Ideal for parts that get dropped, bumped, or stressed.
TransparentOptically clear. You can see fine details through the print. Very difficult to achieve true transparency with FDM due to layer lines.
Flame RetardantResists catching fire or self-extinguishes. Often UL94 rated. For electrical enclosures, automotive components, aerospace parts, or safety-critical applications.
UV ResistantResists degradation from sunlight exposure (UV radiation) and outdoor weather conditions. For outdoor signage, garden equipment, automotive exterior parts, or marine components.