Firefly Blue· AMOLEN PLA Glow-in-the-Dark

AMOLEN

Filament Color

Firefly Blue#1A4FBA

Buy

AMOLEN Store Buy on Amazon

Buy links may earn VisualSpool a small commission, at no extra cost to you. Details.

Your spools

Create your studio Sign in

Photos

No community photos of AMOLEN PLA Glow-in-the-Dark Firefly Blue yet.

Upload your swatch, spool or print with this filament.

Join to add a photo or sign in

AMOLEN PLA Glow-in-the-Dark Firefly Blue Summary

This filament is beginner-friendly to print. Worth watching: it can be low on heat resistance.

Skill level Beginner

Beginner-friendly. Prints reliably at default settings on almost any printer.

Print characteristics

Layer adhesion GoodBed adhesion EasyBridging & overhang ExcellentSpeed sensitivity LowWarping NoneShrinkage 0.2-0.6 %Stringing MinimalOozing MinimalOdor Mild

Strengths

Solid strength for everyday parts
Stiff and rigid, resists flexing
Stays flat, very little warping
Prints clean with minimal stringing
Food-safe potential with the right setup

Things to watch

Softens in heat, not for hot cars or near heat sources
Degrades in sunlight, not ideal for long-term outdoor use
Can be brittle, may crack under sharp impact
Wears down under friction, not for high-wear parts

Color & finish

A solid Firefly Blue filament. It reads as a vivid blue, close to dark slate blue. This filament has embedded glitter that catches the light and a glow-in-the-dark effect after a charge of light.

Finishing

SandablePaintableVapor-smoothableMachinableGlue-friendly

Common uses

Decor & Cosplay Display modelsFigurines & statues

Home & Lifestyle Drawer organizersPlanters

Tabletop & Gaming Board game insertsMiniatures

Specialties

Glitter Bright or translucent base with larger, visible glitter flakes. Large (0.5–2mm) particles. Distinct individual flecks; disco-ball effect.

UV ReactiveDoes not glow in the dark. Only glows brightly under UV blacklight. The effect is instant and stops when the UV light turns off. Available in bright neon colors (pink, green, yellow, orange). Not abrasive.

Glow in the DarkAbsorbs light from the sun or room lighting, then slowly releases it as a glow in the dark. Lasts for minutes to hours. Green is most common. Highly abrasive—use a hardened nozzle.

Spool Specs

DENSITY

1.24 g/cm³

TOLERANCE

±0.02 mm

DIAMETER

1.75 mm

SPOOL SIZE

1000 g

LENGTH

335 m

Filament Print & Drying settings

Nozzle temp	210–230 °C
Bed temp	30–65 °C
Print speed	< 120 mm/s
Flow ratio	1
Nozzle	Hardened / abrasive-resistant nozzle required
Drying	55 °C for 8 h
Moisture sensitivity	Low
Enclosure	Not Required
Part cooling	Max