Updated Jun 27, 2026Added Jun 6, 2026
Firefly Green· AMOLEN PLA Glow-in-the-Dark
Buy links may earn VisualSpool a small commission, at no extra cost to you.
Details.
Your spools
Sign in to see your spools of this filament here, how much is left, and where each one lives.
Photos
No community photos of AMOLEN PLA Glow-in-the-Dark Firefly Green yet.
Upload your swatch, spool or print with this filament.
Join to add a photo
or sign inAMOLEN PLA Glow-in-the-Dark Firefly Green Summary
This filament is beginner-friendly to print. Worth watching: it can be low on heat resistance.
Beginner
Beginner-friendly. Prints reliably at default settings on almost any printer.
Print characteristics
Layer adhesion GoodBed adhesion EasyBridging & overhang ExcellentSpeed sensitivity LowWarping NoneShrinkage 0.2-0.6 %Stringing MinimalOozing MinimalOdor Mild
Strengths
- Solid strength for everyday parts
- Stiff and rigid, resists flexing
- Stays flat, very little warping
- Prints clean with minimal stringing
- Food-safe potential with the right setup
Things to watch
- Softens in heat, not for hot cars or near heat sources
- Degrades in sunlight, not ideal for long-term outdoor use
- Can be brittle, may crack under sharp impact
- Wears down under friction, not for high-wear parts
Color & finish
A solid Firefly Green filament. It reads as a vivid green, close to lime. This filament has embedded glitter that catches the light and a glow-in-the-dark effect after a charge of light.
Finishing
SandablePaintableVapor-smoothableMachinableGlue-friendly
Common uses
Decor & Cosplay
Display modelsFigurines & statues
Home & Lifestyle
Drawer organizersPlanters
Tabletop & Gaming
Board game insertsMiniatures
Specialties
Glitter Bright or translucent base with larger, visible glitter flakes. Large (0.5–2mm) particles. Distinct individual flecks; disco-ball effect.
UV ReactiveDoes not glow in the dark. Only glows brightly under UV blacklight. The effect is instant and stops when the UV light turns off. Available in bright neon colors (pink, green, yellow, orange). Not abrasive.
Glow in the DarkAbsorbs light from the sun or room lighting, then slowly releases it as a glow in the dark. Lasts for minutes to hours. Green is most common. Highly abrasive—use a hardened nozzle.
Spool Specs
1.24 g/cm³
±0.02 mm
1.75 mm
1000 g
335 m
Filament Print & Drying settings
| Nozzle temp | 210–230 °C |
|---|---|
| Bed temp | 30–65 °C |
| Print speed | < 120 mm/s |
| Flow ratio | 1 |
| Nozzle | Hardened / abrasive-resistant nozzle required |
| Drying | 55 °C for 8 h |
| Moisture sensitivity | Low |
| Enclosure | Not Required |
| Part cooling | Max |
More in the Glow-in-the-Dark series
View all 17 colors
Aurora Glow
Blue
Blue Purple
Firefly Blue
Green
Orange
Purple
Rainbow 10m
Rainbow 10m Neon Nightfall
Rainbow 5m
Rainbow Flux
Red
Starry Sky Blue
Starry Sky Green
White
YellowReviews for AMOLEN PLA Glow-in-the-Dark Firefly Green filament
Be the first to review. Join for free or sign in to share your experience and prints with this filament.