Updated Jun 27, 2026Added Jun 6, 2026
Brick Red· AMOLEN PLA Marble
Buy links may earn VisualSpool a small commission, at no extra cost to you.
Details.
Your spools
Sign in to see your spools of this filament here, how much is left, and where each one lives.
Photos
No community photos of AMOLEN PLA Marble Brick Red yet.
Upload your swatch, spool or print with this filament.
Join to add a photo
or sign inAMOLEN PLA Marble Brick Red Summary
This filament is beginner-friendly to print. Worth watching: it can be low on heat resistance.
Beginner
Beginner-friendly. Prints reliably at default settings on almost any printer.
Print characteristics
Layer adhesion GoodBed adhesion EasyBridging & overhang ExcellentSpeed sensitivity LowWarping NoneShrinkage 0.2-0.6 %Stringing MinimalOozing MinimalOdor Mild
Strengths
- Solid strength for everyday parts
- Stiff and rigid, resists flexing
- Stays flat, very little warping
- Prints clean with minimal stringing
- Food-safe potential with the right setup
Things to watch
- Softens in heat, not for hot cars or near heat sources
- Degrades in sunlight, not ideal for long-term outdoor use
- Can be brittle, may crack under sharp impact
- Wears down under friction, not for high-wear parts
Color & finish
A solid Brick Red filament. It reads as a vivid red, close to fire brick. This filament has a flat, matte finish that hides layer lines and a stone-like marbled effect.
Finishing
SandablePaintableVapor-smoothableMachinableGlue-friendly
Common uses
Decor & Cosplay
Display modelsFigurines & statues
Home & Lifestyle
Drawer organizersPlanters
Tabletop & Gaming
Board game insertsMiniatures
Specialties
MarbleContains tiny dark speckles or stone particles suspended in the plastic. Creates a clean, polished stone look and hides layer lines well. Use for statues, vases, and decorative models.
MatteFlat, non-reflective surface that hides layer lines. Surface feels slightly rough or chalky.
Spool Specs
1.23 g/cm³
±0.02 mm
1.75 mm
1000 g
338 m
Filament Print & Drying settings
| Nozzle temp | 210–230 °C |
|---|---|
| Bed temp | 30–65 °C |
| Print speed | < 250 mm/s |
| Flow ratio | 1 |
| Drying | 55 °C for 8 h |
| Moisture sensitivity | Low |
| Enclosure | Not Required |
| Part cooling | Max |
More in the Marble series
View all 10 colors
Cement Grey
Fossil Gradient
Green Schist
Rainbow Rock
Red Limestone
Sedimentary Rock
Turquoise
White Stone
Yellow Feldspar RockReviews for AMOLEN PLA Marble Brick Red filament
Be the first to review. Join for free or sign in to share your experience and prints with this filament.