Yellow Feldspar Rock· AMOLEN PLA Marble
Updated Jun 27, 2026
MarbleGradientMatte
Very easy
Beginner-friendly. Prints reliably at default settings on almost any printer.
Sign up to follow this filament
Your spools, shelves, and drying logs, all in one visual studio.
$27.99/kg
Buy links may earn VisualSpool a small commission, at no extra cost to you.
Details.
Your spools
Sign in to see your spools of this filament here, how much is left, and where each one lives.
AMOLEN PLA Marble Yellow Feldspar Rock Summary
This filament is beginner-friendly to print. Worth watching: it can be low on heat resistance.
Print characteristics
Layer adhesion GoodBed adhesion ModerateBridging & overhang ExcellentSpeed sensitivity ModerateWarping LowShrinkage 0.2-0.6 %Stringing LowOozing LowOdor Mild
Strengths
- Solid strength for everyday parts
- Stiff and rigid, resists flexing
- Stays flat, very little warping
- Prints clean with minimal stringing
- Food-safe potential with the right setup
Things to watch
- Softens in heat, not for hot cars or near heat sources
- Degrades in sunlight, not ideal for long-term outdoor use
- Can be brittle, may crack under sharp impact
- Wears down under friction, not for high-wear parts
Drying
This material is fairly forgiving about moisture. When it needs drying, run it at 40-50 °C for 4-6 h.
Compatibility
Not Required
Max
210–230 °C
30–65 °C
Color
This is a multi-color filament in Orange, Yellow, and Brown.
Finish
This filament has a flat, matte finish that hides layer lines, a stone-like marbled effect, and a color-shifting gradient as it prints.
Finishing
SandablePaintableVapor-smoothableMachinableGlue-friendly
Common uses
🎨 Art & Cosplay
Display modelsFigurines & statues
🏡 Home
Drawer organizersPlanters
🎲 Gaming
Board game insertsMiniatures
Specialties
MarbleContains tiny dark speckles or stone particles suspended in the plastic. Creates a clean, polished stone look and hides layer lines well. Use for statues, vases, and decorative models.
GradientThe color transitions as the print progresses. One spool can start blue and end pink, or cycle through a full rainbow.
MatteFlat, non-reflective surface that hides layer lines. Surface feels slightly rough or chalky.
Spool Specs
1.23 g/cm³
±0.02 mm
1.75 mm
1000 g
338 m
Filament Print & Drying settings
| Nozzle temp | 210–230 °C |
|---|---|
| Bed temp | 30–65 °C |
| Print speed | < 250 mm/s |
| Flow ratio | 1 |
| Drying | 55 °C for 8 h |
| Moisture sensitivity | Low |
| Enclosure | Not Required |
More in the Marble series
View all 10 colors
Brick Red
Cement Grey
Fossil Gradient
Green Schist
Rainbow Rock
Red Limestone
Sedimentary Rock
Turquoise
White StonePhotos
No community photos of AMOLEN PLA Marble Yellow Feldspar Rock yet.
Upload your swatch, spool or print with this filament.
Join to add a photo
or sign inReviews for AMOLEN PLA Marble Yellow Feldspar Rock filament
Be the first to review. Join for free or sign in to share your experience and prints with this filament.