Blue Green· AMOLEN PLA Silk S-Series
Updated Jun 27, 2026
CoextrusionSilkGradientFast Gradient
Very easy
Beginner-friendly. Prints reliably at default settings on almost any printer.
Sign up to follow this filament
Your spools, shelves, and drying logs, all in one visual studio.
Buy links may earn VisualSpool a small commission, at no extra cost to you.
Details.
Your spools
Sign in to see your spools of this filament here, how much is left, and where each one lives.
AMOLEN PLA Silk S-Series Blue Green Summary
This filament is beginner-friendly to print. Worth watching: it can be low on heat resistance.
Print characteristics
Layer adhesion GoodBed adhesion ModerateBridging & overhang ExcellentSpeed sensitivity ModerateWarping LowShrinkage 0.2-0.6 %Stringing LowOozing LowOdor Mild
Strengths
- Solid strength for everyday parts
- Stiff and rigid, resists flexing
- Stays flat, very little warping
- Prints clean with minimal stringing
- Food-safe potential with the right setup
Things to watch
- Softens in heat, not for hot cars or near heat sources
- Degrades in sunlight, not ideal for long-term outdoor use
- Can be brittle, may crack under sharp impact
- Wears down under friction, not for high-wear parts
Drying
This material is fairly forgiving about moisture. When it needs drying, run it at 40-50 °C for 4-6 h.
Compatibility
Not Required
Max
210–240 °C
30–65 °C
Color
This is a multi-color filament in Blue and Green.
Finish
This filament has a silky, high-gloss sheen and a color-shifting gradient as it prints.
Finishing
SandablePaintableVapor-smoothableMachinableGlue-friendly
Common uses
🎨 Art & Cosplay
Display modelsFigurines & statues
🏡 Home
Drawer organizersPlanters
🎲 Gaming
Board game insertsMiniatures
Specialties
CoextrusionTwo colors blended in a single strand; shifts appearance with viewing angle
SilkExtremely smooth and glossy with a satin-like sheen. Color is static and highly reflective.
GradientThe color transitions as the print progresses. One spool can start blue and end pink, or cycle through a full rainbow.
Fast GradientThe color cycles every few inches of filament. A single small print will show several distinct colors.
Spool Specs
1.29 g/cm³
±0.03 mm
1.75 mm
1000 g
322 m
Filament Print & Drying settings
| Nozzle temp | 210–240 °C |
|---|---|
| Bed temp | 30–65 °C |
| Print speed | < 200 mm/s |
| Flow ratio | 1 |
| Drying | 55 °C for 8 h |
| Moisture sensitivity | Low |
| Enclosure | Not Required |
More in the Silk S-Series series
View all 16 colors
Amber Sea
Berry Pop
Black Blue Purple
Black Pink White
Black Red
Black Red Yellow
Black Turquoise Magenta
Blue Pink Green
Blue Pink White
Blue Red Yellow Green
Gold Purple Red
Green Fuchsia
Nebula Ribbon
Red White
TwilightPhotos
No community photos of AMOLEN PLA Silk S-Series Blue Green yet.
Upload your swatch, spool or print with this filament.
Join to add a photo
or sign inReviews for AMOLEN PLA Silk S-Series Blue Green filament
Be the first to review. Join for free or sign in to share your experience and prints with this filament.