Updated Jul 8, 2026Added Jul 8, 2026
Slate Gray· Overture PLA Rock
$23.99/kg
Buy links may earn VisualSpool a small commission, at no extra cost to you.
Details.
Your spools
Sign in to see your spools of this filament here, how much is left, and where each one lives.
Photos of Slate Gray · Overture PLA Rock
Photos
No community photos of Overture PLA Rock Slate Gray yet.
Upload your swatch, spool or print with this filament.
Join to add a photo
or sign inOverture PLA Rock Slate Gray Summary
This filament is beginner-friendly to print. Worth watching: it can be low on heat resistance.
Beginner
Beginner-friendly. Prints reliably at default settings on almost any printer.
Print characteristics
Layer adhesion GoodBed adhesion EasyBridging & overhang ExcellentSpeed sensitivity LowWarping NoneShrinkage 0.2-0.6 %Stringing MinimalOozing MinimalOdor Mild
Strengths
- Solid strength for everyday parts
- Stiff and rigid, resists flexing
- Stays flat, very little warping
- Prints clean with minimal stringing
- Food-safe potential with the right setup
Things to watch
- Softens in heat, not for hot cars or near heat sources
- Degrades in sunlight, not ideal for long-term outdoor use
- Can be brittle, may crack under sharp impact
- Wears down under friction, not for high-wear parts
Color & finish
A solid Slate Gray filament. It reads as a blue, close to light slate gray. This filament has a flat, matte finish that hides layer lines and a stone-like marbled effect.
Finishing
SandablePaintableVapor-smoothableMachinableGlue-friendly
Common uses
Decor & Cosplay
Display modelsFigurines & statues
Home & Lifestyle
Drawer organizersPlanters
Tabletop & Gaming
Board game insertsMiniatures
Specialties
MarbleContains tiny dark speckles or stone particles suspended in the plastic. Creates a clean, polished stone look and hides layer lines well. Use for statues, vases, and decorative models.
MatteFlat, non-reflective surface that hides layer lines. Surface feels slightly rough or chalky.
Spool Specs
1.37 g/cm³
±0.02 mm
1.75 mm
1000 g
303 m
Filament Print & Drying settings
| Nozzle temp | 190–230 °C |
|---|---|
| Bed temp | 50–70 °C |
| Print speed | 60–300 mm/s |
| Flow ratio | 1 |
| Drying | 50 °C for 7 h |
| Moisture sensitivity | Low |
| Enclosure | Not Required |
| Part cooling | Max |
More in the Rock series
View all 16 colors
Alpine Forest
Barrier Reef
Desert Bluff
Fossil Rock
Haze Gray
Marigold Yellow
Mist Gray
Moonlight Gray
Muted Gray
Painted Hills
Pink Lake
Rainbow
Rock White
Sedimentary Rock
Turquoise GreenReviews for Overture PLA Rock Slate Gray filament
Be the first to review. Join for free or sign in to share your experience and prints with this filament.