Black + Red· SUNLU PLA Dual Matte
MatteCoextrusion
Very easy
Beginner-friendly. Prints reliably at default settings on almost any printer.
Sign up to follow this filament
Your spools, shelves, and drying logs, all in one visual studio.
Your spools
Sign in to see your spools of this filament here, how much is left, and where each one lives.
SUNLU PLA Dual Matte Black + Red Summary
This filament is beginner-friendly to print. Worth watching: it can be low on heat resistance.
Print characteristics
Layer adhesion GoodBed adhesion ModerateBridging & overhang ExcellentSpeed sensitivity ModerateWarping LowShrinkage 0.2-0.6 %Stringing LowOozing LowOdor Mild
Strengths
- Solid strength for everyday parts
- Stiff and rigid, resists flexing
- Stays flat, very little warping
- Prints clean with minimal stringing
- Food-safe potential with the right setup
Things to watch
- Softens in heat, not for hot cars or near heat sources
- Degrades in sunlight, not ideal for long-term outdoor use
- Can be brittle, may crack under sharp impact
- Wears down under friction, not for high-wear parts
Drying
This material is fairly forgiving about moisture. When it needs drying, run it at 40-50 °C for 4-6 h.
Compatibility
Not Required
Max
195–220 °C
35–65 °C
Color
This is a multi-color filament in Black and Red.
Finish
This filament has a flat, matte finish that hides layer lines.
Finishing
SandablePaintableVapor-smoothableMachinableGlue-friendly
Common uses
🎨 Art & Cosplay
Display modelsFigurines & statues
🏡 Home
Drawer organizersPlanters
🎲 Gaming
Board game insertsMiniatures
Specialties
MatteFlat, non-reflective surface that hides layer lines. Surface feels slightly rough or chalky.
CoextrusionTwo colors blended in a single strand; shifts appearance with viewing angle
Spool Specs
1.24 g/cm³
±0.03 mm
1.75 mm
1000 g
335 m
Filament Print & Drying settings
| Nozzle temp | 195–220 °C |
|---|---|
| Bed temp | 35–65 °C |
| Flow ratio | 1 |
| Drying | 40-50 °C for 4-6 h |
| Moisture sensitivity | Low |
| Enclosure | Not Required |
More in the Dual Matte series
View all 8 colors
Photos
No community photos of SUNLU PLA Dual Matte Black + Red yet.
Upload your swatch, spool or print with this filament.
Join to add a photo
or sign inReviews for SUNLU PLA Dual Matte Black + Red filament
Be the first to review. Join for free or sign in to share your experience and prints with this filament.