Bambu Lab PA (Nylon) PA6-GF
Filaments in this series
1.75 mm
1000 g
1.14 g/cm³
365 m
260–290 °C
80–100 °C
1
Drying: 70-90 °C for 8-24 h
Material properties · 53 fields
Inherited from PA (Nylon).
Printing requirements
250-290 °C
90-110°C
Off
Off
Heated (55-75°C) · enclosure needed
Medium
HEPA + Carbon Filtration
Removes both ultrafine particles and many VOCs. Best all-around filtration.
1
Required (Brim, Raft, Glue (adhesion), Magigoo)
Required
Required
70-90 °C for 8-24 h
Printing characteristics
Process-Dependentⓘ
Moderate
0.8-2.0 %
Requires Special Prepⓘ
Moderate
Exceptionalⓘ
Fairⓘ
Moderateⓘ
Moderateⓘ
Very Highⓘ
60 mm/s
Very High
Moderate
High
Material properties
1.10 g/cm³
Medium · 50 MPa
Medium · 1.50 GPa
Medium · 8.0 kJ/m²
Semi-flexible · 60% elong.
Low · 60 °C HDT
50 °C
High · 1.50% in 24h
Low · 45 MPa
Medium · 1.40 GPa
Fair
Excellent
Exceptional
Fair
Fair
Good
Good
Exceptional
Medium 70-80D
None
With proper processing
Post-processing
Fair
Fair
No
Fair
Good
Recommended
Series created Jun 4, 2026
Specialties
Tough / Impact ResistantEngineered to resist breaking, cracking, or shattering under impact. Unlike standard PLA, which snaps, this flexes slightly before breaking. Ideal for parts that get dropped, bumped, or stressed.
Wear ResistantResists surface wear from friction and sliding. Good for gears, bushings, conveyor parts, or any component that rubs against other surfaces.
High StrengthResists bending or pulling apart under heavy load. Very stiff.
Chemical ResistantResists damage from oils, fuels, acids, industrial chemicals or solvents. For laboratory equipment, fuel system components, or chemical storage.
Heat ResistantWithstands elevated temperatures (hot car, warm electronics) without deforming. Printable on standard printers. HDT ~80-120°C.
Low Friction Naturally slippery surface. Low coefficient of friction. For bearings and sliding parts.