Added Jun 6, 2026
Black· Bambu Lab PA (Nylon) PA6-GF
AMS compatible
Buy links may earn VisualSpool a small commission, at no extra cost to you.
Details.
Your spools
Sign in to see your spools of this filament here, how much is left, and where each one lives.
Photos
No community photos of Bambu Lab PA (Nylon) PA6-GF Black yet.
Upload your swatch, spool or print with this filament.
Join to add a photo
or sign inBambu Lab PA (Nylon) PA6-GF Black Summary
This filament is demanding to print. Worth watching: it can be prone to warping and very moisture-sensitive.
Expert
Expert. Best suited to experienced makers: enclosure, precise temps, and patience.
Print characteristics
Layer adhesion ExceptionalBed adhesion Requires Special PrepBridging & overhang FairSpeed sensitivity HighWarping HighShrinkage 0.8-2.0 %Stringing ModerateOozing ModerateOdor Moderate
Strengths
- Solid strength for everyday parts
- Resists oils, solvents, and chemicals
- Wear-resistant for moving and rubbing parts
- A little give without being floppy
- Layers bond strongly for clean, watertight prints
- Food-safe potential with the right setup
Things to watch
- Prone to warping, use a heated bed and ideally an enclosure
- Extremely thirsty, keep it sealed with desiccant and dry it right before printing
- Softens in heat, not for hot cars or near heat sources
- Shrinks as it cools, which can affect dimensional accuracy
- Fussy about bed adhesion, use a brim, glue, or a textured plate
Color & finish
A solid Black filament. It reads as a near-black, close to midnight blue.
Finishing
Machinable
Specialties
High StrengthResists bending or pulling apart under heavy load. Very stiff.
Heat ResistantWithstands elevated temperatures (hot car, warm electronics) without deforming. Printable on standard printers. HDT ~80-120°C.
Tough / Impact ResistantEngineered to resist breaking, cracking, or shattering under impact. Unlike standard PLA, which snaps, this flexes slightly before breaking. Ideal for parts that get dropped, bumped, or stressed.
Wear ResistantResists surface wear from friction and sliding. Good for gears, bushings, conveyor parts, or any component that rubs against other surfaces.
Chemical ResistantResists damage from oils, fuels, acids, industrial chemicals or solvents. For laboratory equipment, fuel system components, or chemical storage.
Low Friction Naturally slippery surface. Low coefficient of friction. For bearings and sliding parts.
Spool Specs
1.14 g/cm³
±0.03 mm
1.75 mm
1000 g
365 m
Filament Print & Drying settings
| Nozzle temp | 260–290 °C |
|---|---|
| Bed temp | 80–100 °C |
| Print speed | < 130 mm/s |
| Flow ratio | 1 |
| Drying | 70-90 °C for 8-24 h |
| Moisture sensitivity | Very High |
| Enclosure | Required |
| Part cooling | None |
| Dry box while printing | Keep the spool in a dry box while printing |
More in the PA6-GF series
View all 8 colors
Reviews for Bambu Lab PA (Nylon) PA6-GF Black filament
Be the first to review. Join for free or sign in to share your experience and prints with this filament.