View

Orange· Bambu Lab PA (Nylon) PA6-GF

Name: Bambu Lab PA (Nylon) PA6-GF Orange
Brand: Bambu Lab

Bambu Lab· SKU: 72200

High StrengthHeat ResistantTough / Impact ResistantWear ResistantChemical ResistantLow Friction

AMS compatible

Ease of use Very hard

Demanding. Best suited to experienced makers: enclosure, precise temps, and patience.

Filament Color

Orange#FF4800

Buy

Bambu Lab Store

Buy links may earn VisualSpool a small commission, at no extra cost to you. Details.

Your spools

Create your studio Sign in

Bambu Lab PA (Nylon) PA6-GF Orange Summary

This filament is demanding to print. Worth watching: it can be very moisture-sensitive and low on heat resistance.

Print characteristics

Layer adhesion ExceptionalBed adhesion Requires Special PrepBridging & overhang FairSpeed sensitivity Very HighWarping ModerateShrinkage 0.8-2.0 %Stringing ModerateOozing ModerateOdor Moderate

Strengths

Solid strength for everyday parts
Resists oils, solvents, and chemicals
Wear-resistant for moving and rubbing parts
A little give without being floppy
Layers bond strongly for clean, watertight prints
Food-safe potential with the right setup

Things to watch

Can warp on large or sharp-cornered prints
Extremely thirsty, keep it sealed with desiccant and dry it right before printing
Softens in heat, not for hot cars or near heat sources
Shrinks as it cools, which can affect dimensional accuracy
Fussy about bed adhesion, use a brim, glue, or a textured plate

Drying

This material is extremely hygroscopic, it pulls moisture from the air very quickly. When it needs drying, run it at 70-90 °C for 8-24 h. Keep it in a heated dry box while printing for the cleanest results.

Compatibility

AMS

Compatible

ENCLOSURE

Required

PART COOLING

None

WHILE PRINTING

Keep in a dry box

NOZZLE TEMP

260–290 °C

BED TEMP

80–100 °C

Color

A solid Orange filament. It reads as a vivid orange, close to orange red.

Finishing

Machinable

Specialties

High StrengthResists bending or pulling apart under heavy load. Very stiff.

Heat ResistantWithstands elevated temperatures (hot car, warm electronics) without deforming. Printable on standard printers. HDT ~80-120°C.

Tough / Impact ResistantEngineered to resist breaking, cracking, or shattering under impact. Unlike standard PLA, which snaps, this flexes slightly before breaking. Ideal for parts that get dropped, bumped, or stressed.

Wear ResistantResists surface wear from friction and sliding. Good for gears, bushings, conveyor parts, or any component that rubs against other surfaces.

Chemical ResistantResists damage from oils, fuels, acids, industrial chemicals or solvents. For laboratory equipment, fuel system components, or chemical storage.

Low Friction Naturally slippery surface. Low coefficient of friction. For bearings and sliding parts.